Kreg K2000 Pro Pack: Discontinued — What to Buy Instead

The K2000 Pro Pack was Kreg’s bench-mounted pocket-hole system from the generation before the K3, K4 and K5: a three-guide jig on a base, with a toggle clamp, a stepped drill bit, a driver and a case of screws. For a long time it was how most people first met pocket-hole joinery.

It is no longer made. Kreg’s current jigs are the 320, the 520PRO and the 720PRO, and the K-series numbering ended several revisions ago.

Should you keep using one?

Yes, if you have one and it works. The joint the K2000 drills is the same joint a 720PRO drills — same angle, same screw, same strength. Nothing about the geometry has been improved in a way that makes old holes worse.

The parts that wear are the hardened drill guides and the stepped bit, and the bit is still a stock item because it has not changed. Guides on the old jigs are pressed in rather than replaceable, so a jig with visibly worn guides is genuinely at the end of its life.

Check one thing: that the stop collar still grips the bit properly. A collar that slips drills through the workpiece, and that is the most common reason an old Kreg setup starts producing blowouts.

What replaces it

The Kreg Pocket-Hole Jig 720PRO is the current equivalent, linked below. Two changes matter compared with the K2000.

The clamp is integrated and auto-adjusting: it sets its own pressure for the stock thickness rather than needing a toggle clamp set by hand each time you change material. On a project mixing 3/4 in ply and 1-1/2 in framing, that removes a step per part.

The guides are removable, which is what makes micro-pocket and other accessory guides possible, and it means the wear part is replaceable rather than terminal.

If you want the cheapest route back to working, the clamp-on R3 does the same joint for a fraction of the price — it simply gives up the base and the integrated clamp.