Ozito MSS-001 Mitre Saw Stand — and the Amazon Alternative

Ozito is Bunnings’ house brand and is not sold through Amazon in any market. If you want the MSS-001 specifically, that is where it lives.

What matters in a mitre saw stand is worth setting out, because the frame is the part people compare and the supports are the part that does the work.

Supports, not legs

A mitre saw cuts accurately when the workpiece sits flat on the table and flush against the fence along its whole length. A three metre length of architrave on a saw with nothing supporting the far end does neither — it sags, lifts off the fence at the cut, and the mitre closes wrong.

So the specification that matters is how far the supports extend, whether they lock, and whether they adjust to the height of your saw’s table.

Everything else — folding legs, wheels, weight — is convenience.

Getting the height right

This is the setup step people skip. The supports must be level with the saw’s own table, or very slightly below it. A support a few millimetres high tips the workpiece and lifts its far end off the table, which angles every cut.

Set it with a straight edge across the saw table and the support, every time you set the stand up.

The mounting brackets

Universal brackets that bolt to the saw and then clip into the stand are the difference between a stand you use and one you do not. If mounting the saw takes ten minutes with spanners, the saw ends up living on the stand permanently, at which point you have bought a bad bench.

The fixed-shop alternative

If your saw never leaves the shop, a mitre station — a bench with the saw recessed so its table is flush with the bench top, and a continuous fence with a stop block running both ways — is better than any stand. It costs a sheet of ply and an afternoon, and it makes repeat cuts trivial.

Stands exist for saws that move. The DEWALT scored here is the standard answer for that case.